Hargreaves Halifax HD4067 100mm Adjustable Steel Drain Pipe Bracket
Unavailable for Online Ordering
Call for Availability100mm adjustable steel bracket for supporting Halifax Drain pipework wherever a run is exposed above ground.
- Diameter - 100mm, for supporting Halifax Drain pipework where it is exposed above the trench, such as at a wall or foundation entry point.
- Adjustment - Fixing slot design allows use with threaded rod for adjustable positioning.
- Spacing - Hargreaves recommend support every 1.5 metres on horizontal runs, within the 3 metre maximum set by BS EN 12056-2.
- Scope - A support accessory, not covered by the BS EN 877 standard or Kitemark scheme.
The Halifax HD4067 is a 100mm adjustable steel bracket for supporting Halifax Drain pipework wherever it is not fully buried, such as where a run passes through a wall, foundation or exposed section before entering the ground.
Support spacing
BS EN 12056-2 requires that supports on a horizontal pipe run are no more than 3 metres apart. Hargreaves recommend a closer interval of every 1.5 metres, with the first bracket positioned within 500mm of the first coupling, to aid installation and give greater rigidity to the run.
Fixing
- Slot - The bracket's fixing slot accepts threaded rod, allowing the pipe position to be adjusted during installation.
- Structure - Suitability of the fixing depends on the supporting structure, and should be assessed by the designer or installer for each project.
This bracket is a support accessory and, unlike the Halifax Drain pipes and fittings, is not itself covered by the BS EN 877 standard or the BSI Kitemark. See the manufacturer's Halifax Technical Guide for further installation guidance.