Hargreaves Halifax HD8067 200mm Adjustable Steel Drain Pipe Bracket
Unavailable for Online Ordering
Call for AvailabilitySteel bracket sized for 200mm Halifax Drain pipe, wherever a run comes up out of the ground and needs holding against a wall or structure.
- Sizing - Made to suit 200mm Halifax Drain pipework at entry and exit points above the trench.
- Slot - Fixing slot takes a threaded rod, so the pipe's exact position can be adjusted while fitting it.
- Interval - Hargreaves' own guidance is a bracket every 1.5 metres on a horizontal run, tighter than the 3 metre maximum in BS EN 12056-2.
- Certification - A fixing accessory rather than a pressure-bearing part - outside the scope of the BS EN 877 standard and Kitemark.
Most of a Halifax Drain run stays buried, but wherever the 200mm pipe comes up out of the ground - through a wall, at a foundation, or along an exposed stretch - the HD8067 steel bracket is what holds it in place.
How far apart
BS EN 12056-2 sets a 3 metre maximum between supports on a horizontal run. Hargreaves' own guidance goes tighter still: a bracket every 1.5 metres, with the first one within 500mm of the nearest coupling, which makes the run easier to install and noticeably stiffer once it is up.
Fixing
- Slot - Takes a threaded rod through the fixing slot, so position can be fine-tuned while the pipe goes in.
Service life
Correctly installed and maintained, cast iron drainage of this kind can remain in service for more than 100 years, and is fully recyclable without any loss of its original properties at the end of that life.
As a fixing accessory rather than a pressure-bearing pipe component, this bracket sits outside the scope of BS EN 877 and the Kitemark that cover the pipes and fittings themselves. See the manufacturer's Halifax Technical Guide for further installation guidance.